1959-63 Rolls Royce Phantom V Park Ward

Will turn an old friction-toy into a curbside/Semislammer model. Here's what I'll be using:

First Wheel is finished, I had to reduce the width on the front Wheels to make them fit the chosen tires.

Good job

a new project ,nice start !!

ben moi je voie pas les photos sa l'air fermer ???????

essaie de faire un nettoyage d'historique pourvoir sinon ça dépend peut être de ton moteur de recherche ,faudrait demander a heroes il et plus calé que moi !!

All 4 Wheels finished except for centercaps/spinners....



I've also started shaving the handles from the body

c'est ok je peut regarder sa va en jeter un max avec c'est roulette.

The stock "chassieplate" has been slightly modified to accept the new Wheels:

Making my own centercup-logos for the Wheels :

Its the TOP !!!! Congratulation

pal mal le rendu .

Started to correct the body-lines today.

Almost done with the right side body mods:

Found Another set of tires (with crappy, unusable Wheels) and will use them instead. I may be able to modify the wire-Wheels to match these tires...

I finally decided on Wheels for this build. Imagine these Wheels finished off with Three-blade knock-off spinners !

I wasn't really pleased with the look of the body compared to pic's of the real car. So, this evening I cut out about 4 mm in length behind the rear Wheels.

Now it looks just about the same as in this Picture (photoshopped)



The red lines show where I will either ADD plastic or take some material away.

good job .

puma80 a écrit:

good job .

+1